With craftsman’s spirit, SBM always tries to do better.

Toggle Navigation

Sand Manufacturing Machine

Psted On 2018-09-15 18:14:34
Sand Manufacturing Machine

Material characteristics affect the output of Sand Manufacturing Machine

Different materials, there will be some differences in hardness, viscosity, humidity, etc., and the amount of sand produced by the Sand Manufacturing Machine will be different. details as follows:

1, the viscosity of the material

The greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand making chamber in the Sand Manufacturing Machine. If it cannot be cleaned in time, it will seriously affect the working efficiency of the Sand Manufacturing Machine, and it will seriously affect the normal operation of the Sand Manufacturing Machine. Therefore, when selecting materials, it must be noted that the viscosity of the material should not be too large.

2, the composition of the material

The more fine powder contained in the material before sand making, the more it affects sand making, because these fine powders tend to adhere and affect the transport. Therefore, for materials with a high content of fine powder, the sieve should be sieved one time in advance, and the fine powder should be screened out from the material as much as possible to avoid affecting the normal operation of the Sand Manufacturing Machine.

3, the humidity of the material

If the water content is high, the material is easily adhered when it is crushed in the Sand Manufacturing Machine, and is easily clogged during the feeding process, resulting in a reduced sand making capacity.

To solve this problem, firstly, the material humidity should be strictly controlled when the material is selected. If the material humidity is too large, the sunshine or air drying method can be used to reduce the percentage of moisture in the material.